Electrophoresis process equipment layout pay attention to the problem

Complete sets of electrophoresis equipment has the following main equipment composition: electrophoresis tank, washing tank, spray tank before schistosity,electrophoresis, electrophoresis power machine, ultrafiltration reverse osmosis pure water machine, oven or oven. Electrophoresis process equipment layout includes the complete set of equipment, and equipped with device parameters,layout and operation environment etc.. The process layout good can helpenterprises to develop production activities, increase economic benefits of enterprises; on the contrary, not good layout will hinder the normal development of the production, the development of enterprises and the overall market is extremely unfavorable. The following four questions about the mainattention.

1, the yield can reach the designed program; a, some of the design does not consider the hanging method of electrophoresis equipment; B, without considering the hanging interval; C, without considering the interference on the downhill, horizontal turning; D, the production time is not considering therejection rate, coating equipment utilization rate, product peak production capacity. The above error resulted in yield can reach the designedprogramme.

2, electrophoresis equipment process time is not enough: a some of the design in order to reduce the cost by reducing the processing time to achieve the purpose of. Common: production line coating pretreatment transitionperiod of time is not enough, cause the string fluid; B curing is not considered when heating time, causing bad curing; C paint leveling time enough, causing Qimo leveling enough; after curing insufficient cooling, spray paint (or parts)workpiece overheating.

3, conveying equipment, improper design: there are many, the transportation mode of workpiece on the improper design, production capacity, process operation, the upper and lower parts have adverse consequences. There is a common overhead chain conveyor, the load capacity, towing capacitycalculation is needed and the interference of drawing. Speed of the chain ofequipment should also have the corresponding requirements. Coating equipment stability, the chain of synchronization are required.

4, electrophoresis improper equipment selection: due to product requirements are different, the selection of equipment are also different, and a variety of coating equipment has its advantages, also has its disadvantages. And designcan't give the user instructions, making after the discovery was not satisfied.For example, dusting oven with air curtain workpiece heat insulation,cleanliness requirements without installation of purification equipment and so on. This type of error is the most common electrophoresis process equipmentlayout error.