Piping installation points
1, long-term use of the pipeline must be prepared to support, in order to prevent leakage of the joint position and operation pipeline pipeline damage due to vibration.
2, the inlet pipe must be installed forefront bottom valve or check valve or filter, the position can not close the air mixing tube, avoid inhaling the air and reduce the amount of turning joints and shorten the amount of inlet pipe from the inlet pipe diameter can not be less than pump caliber.
3, if the suction line longer or turn away more, must be installed in the suction piping water holes, controlled by the injection valve, if necessary, this added to the liquid, fill inlet line.
4, try not to be installed in the machine outdoors. If it must be installed in the outdoor awning takes to prevent rain soaked and ultraviolet radiation.
5, note the use of the pipe should be preceded by chemical liquid physical properties, temperature conditions, with the actual need to select the appropriate material tube. Such as: the temperature at 60 ° C or more, you should choose to use PP pipe fittings.
6, piping tube should pay attention not any residual material or debris, if the water is added to the washing lines.
7, when the inlet pipe using soft materials piping, attention should be secured to prevent movement or float level. In the slot portion of the conduit can be employed a hard material preferred.
8, the installation should filter select the level of firm ground, keep the body vertical and secure.
9, the filter pump Po entrance height if less than liquid tank liquid, should pay attention to the need to install piping check where the entrance and avoid the phenomenon of liquid siphon pump for repair.